From 0000000000000000000000000000000000000000 Mon Sep 17 00:00:00 2001
From: =?UTF-8?q?Ond=C5=99ej=20Jirman?= <megi@xff.cz>
Date: Thu, 12 Jan 2017 16:34:57 +0100
Subject: clk: sunxi-ng: Set maximum P and M factors to 1 for H3 pll-cpux clock

When using M factor greater than 1 system is experiencing
occasional lockups. P factor should only be used for clock
speeds below 288MHz. We don't use such speeds in the mainline
kernel.

This change was verified to fix lockups with PLL stress
tester available at https://xff.cz/git/arisc-firmware/.

Note that M factor must not be used outside the kernel either,
so for example u-boot needs a similar patch.

Signed-off-by: Ondrej Jirman <megi@xff.cz>
---
 drivers/clk/sunxi-ng/ccu-sun8i-h3.c | 24 ++++++----
 1 file changed, 15 insertions(+), 9 deletions(-)

diff --git a/drivers/clk/sunxi-ng/ccu-sun8i-h3.c b/drivers/clk/sunxi-ng/ccu-sun8i-h3.c
index 74274c17efb3..da448d659381 100644
--- a/drivers/clk/sunxi-ng/ccu-sun8i-h3.c
+++ b/drivers/clk/sunxi-ng/ccu-sun8i-h3.c
@@ -25,15 +25,21 @@
 
 #include "ccu-sun8i-h3.h"
 
-static SUNXI_CCU_NKMP_WITH_GATE_LOCK(pll_cpux_clk, "pll-cpux",
-				     "osc24M", 0x000,
-				     8, 5,	/* N */
-				     4, 2,	/* K */
-				     0, 2,	/* M */
-				     16, 2,	/* P */
-				     BIT(31),	/* gate */
-				     BIT(28),	/* lock */
-				     CLK_SET_RATE_UNGATE);
+static struct ccu_nkmp pll_cpux_clk = {
+	.enable		= BIT(31),
+	.lock		= BIT(28),
+	.n		= _SUNXI_CCU_MULT(8, 5),
+	.k		= _SUNXI_CCU_MULT(4, 2),
+	.m		= _SUNXI_CCU_DIV_MAX(0, 2, 1),
+	.p		= _SUNXI_CCU_DIV_MAX(16, 2, 1),
+	.common		= {
+		.reg		= 0x000,
+		.hw.init	= CLK_HW_INIT("pll-cpux",
+					      "osc24M",
+					      &ccu_nkmp_ops,
+					      CLK_SET_RATE_UNGATE),
+	},
+};
 
 /*
  * The Audio PLL is supposed to have 4 outputs: 3 fixed factors from
-- 
Armbian

